hi again, this question will sound daft but hear goes i have seen some side steps for sale but the ad says they are for short wheel base freelander to be honest i don't know what is the short one and which is the long one i have looked on Google pics but still no wiser so can someone let me know thanks :
andybelfast
Member
I have a Kalahari too. I just measured my sidesteps and they are 1.66m long. There are 3 mounting brackets on each and they are adjustable along the length of the step. Hope this helps.
teddywood1
Well-Known Member
3 mounting brakets ? there are only 2 the length of the bodies on 3 door and 5 door are the same there is a hight difference the 5 door is 20mm higher and the rivenuts for fixing the steps are 10mm hope this helps you out
thanks singvogel hope your right cos i have now bought em so if they dont fit its tough they: will have to go back on ebay. have you any idea what size bolts i will need for them. eBay - The UK's Online Marketplace
Singvogel
Well-Known Member
Hi,
You need the 10mm rivenuts that teddywood1 was mentioning a couple of posts back.
S.
Singvogel
Well-Known Member
tezzer,
Have you registered on Topix? Link here:
TOPIx - TOPIx
It's free and full of info on your car if you put in the VIN number.
Some of the service and workshop stuff is subscription, but all the manuals and the fitting instructions for things like side steps are available free.
I've just checked it and the instructions show diagrams of where the rivenuts go and all the info you get with when you buy a new set from a dealer.
Should be a help to you.
Singvogel.
Have you registered on Topix? Link here:
TOPIx - TOPIx
It's free and full of info on your car if you put in the VIN number.
Some of the service and workshop stuff is subscription, but all the manuals and the fitting instructions for things like side steps are available free.
I've just checked it and the instructions show diagrams of where the rivenuts go and all the info you get with when you buy a new set from a dealer.
Should be a help to you.
Singvogel.
Make sure you get the brackets and check that they are in good nick, they're like rocking horse poop.
I had to remake the brackets as mine just rusted away, getting the angles correct was a bit tricky and had to use trial error for the correct hole positions, (front and rear are different).
But as already stated, they're all the same sill length.
Si
I had to remake the brackets as mine just rusted away, getting the angles correct was a bit tricky and had to use trial error for the correct hole positions, (front and rear are different).
But as already stated, they're all the same sill length.
Si
Richard Martin
Well-Known Member
Have a look here Homemade Riv-nut Tool and here http://www.bearmach.com/downloads/Technical PDF/BFA 2006,7.pdf
now i know what you mean, when i was plumbing i used thousands of similar fixings to these for hanging rads on cavity walls, i may still have some of these and the tool to fix em in place, nice link Richard. are the holes pre-drilled in the chassis or do you have to drill em your self?
teddywood1
Well-Known Member
if you have not got the tool for doing the rivnuts here is how to do it put a washer on the rivnut hole small enough so not to go over the nuts then put 3 nuts on tighten two of the nuts together (top two). so they are locked and put a spanner on them to hold then the bottom nut should be tightened against the washer holding the rivenut in place make sure first you have the proper holes in the chassie line you step hangers up with the holes so you know which is which there are some bigger holes probably behind tape but these are not the ones you will see when you get under
