I have the same as you linked, installed it back in January, was abit of a fiddle to get it right, but didn't have to cut or weld anything to get it to fix right (apart from the hole it pokes through) but it does rest on the anti roll bar some reason, it won't go any higher, in two minds to take arb off but don't know yet don't fancy that, also they state that you should remove arb then fit and put the arb back on but I never done that went on with out removing. I can get you pictures if you need them might be best to do it when it's lighter out side.
 
Yea if you can get pics of it all in place that would be good I can't for the life of me get it to fit, had it all in place but as I said exit wanted to go through where the rear mud flap bracket is on mine so sitting way to forward
 
Yea if you can get pics of it all in place that would be good I can't for the life of me get it to fit, had it all in place but as I said exit wanted to go through where the rear mud flap bracket is on mine so sitting way to forward

Alright, I shall see if I can find my light and see if the pictures are any good if not ill do it in morning, I don't have a mid box or back box on mine, doesn't sound to loud unless you give it abit large, also i've retro fitted fixing brackets to stop rattling in the hole.

Edit
pictures
image1.jpg

image2.jpg

image3.jpg

image4.jpg

image5.jpg

image6.jpg

image7.jpg

image8.jpg


I hope this helps, let me know if you need any more help or info. :)
 
Last edited:
Mine passes no problem too, and have a look at some of the defenders, as they are pretty much side exhausts ;)
 
Cheers helps a lot dint suppose you could get me a dimension from the front and the back of the rear wing to see how central it is on the wing?


Alright, I shall see if I can find my light and see if the pictures are any good if not ill do it in morning, I don't have a mid box or back box on mine, doesn't sound to loud unless you give it abit large, also i've retro fitted fixing brackets to stop rattling in the hole.

Edit
pictures
image1.jpg

image2.jpg

image3.jpg

image4.jpg

image5.jpg

image6.jpg

image7.jpg

image8.jpg


I hope this helps, let me know if you need any more help or info. :)
 
Cheers helps a lot dint suppose you could get me a dimension from the front and the back of the rear wing to see how central it is on the wing?


So you want to know where abouts my exit is on the wing panel? Mine will most likely be different as my rear panels cut for bigger tyres but I can get measurements for you.
 
Basically yes if you could as like I said mine seems to want to come out more in the wheel arch area not the panel lol
 
Cheers mate, not sure if I can use this one just yet may have to cut it or make my own from scratch what every I try it just don't fit
 
I bought one of these for mine last year. Spent bloody ages trying to get it to fit with no luck. It was way too short and would've come out through my flexi arch, I got a friend to extend it so came out the rear quarter further back where it should. However I then discovered it was hitting the A frame when off roading. In the end I threw it away and got a custom one made from center box to tip which only cost £30 more than that pipe did.
 
Cheers for the above info I think mine is gonna be the exact same as the above if I extended it, it won't sit right by the A frame still, just messaged them and will await a reply about getting a refund
 

Similar threads