Just cut it off after the centre joint , leave a few inches ! Then cut up the rest of what's left using the bends etc weld it up , tacking it first is wise!! Then when it sits nice and doesn't touch anywhere add a mount or two ! Using the old bits again ! When you can see where it exits then cut a hole ! Bit bigger than pipe size! Start it up and smile !!!!!!!
MPfive
Active Member
Im planning mine at the mo. Im running a straight through middle with sports rear section. My plan is to leave as much in as possible and just cut the back box off,on ebay theres a place selling 45° and 90° 3"bends. I was going to go for the 45° and weld it on and cut a hole in the rear panel for it. Might have to fit middle box back on,have to see how loud it it. Good reference would be auf wiedesehen pets builds of his awesome disco.
auf_wiedersehen_pet
Well-Known Member
:clap2::clap2::clap2::clap2: Thank you.
http://www.landyzone.co.uk/lz/f8/auf_wiedersehen_pets-build-thread-206921.html
You need Post # 35.
MPfive
Active Member
Did min the other week,easy to do. I got a 2 1/2" 45*bend off ebay,a couple of clamps and nicked a bit of stainless off a mate. Straight through exhaust now,doesn't sound much louder than the britpart sports exhaust I cut out.Only advice would be to clean your landy before hand
