top-cat
Well-Known Member
Ive decided to sell her as im just not using her, she has covered less than 1000 miles in 3 years.
Im after a motorbike so could be interested in a px why
Full roll cage c/w rear wrap around with 8x chassis mountings. Full roof and side diagonals and tree sliders
Cage mounted swing away spare wheel carrier.
Mach 5 wheels with silverstone exreme 35x10.50 tyres. (not to be confused with copies) These are not remoulded tyres
Qt 2 degree corrected radius arms
Qt rose jointed trailing arms
Hd wide angle props
Adjustable rose jointed panhard rod
pro-comp 5 inch pin to pin shocks with relocated chassis mounts
dislocation cones front with cor 4 dislocating spring slider system to the rear, (never ever have relocation problems again)
Wrap around diff guards front and rear
Fuel tank guard
custom made 3 point chassis mounted rear recovery device
straight through side exit exhaust
Extended brake lines
Axle and gearbox`s raised breathers
Arb air locking diffs front and rear
Arb large capacity onboard compressor with tyre inflation
Full pro rock and tree sliders
Huge superwinch e10 45kn (10116 lbs) With Bow 2 motor and 2x remotes and dash controls + wiring for
free spool. (Warn 8247 is 9000 lbs)
South down stainless snorkle (cage mounted)
Twin 110A batteries under seat profesionally wired via isolators so either battery can be used over night camping reserving the other for starting the next morning.
1000w inverter
Raptor dash profesionally wired and installed with carling switches for compressor, diffs. winch and lighting
2 x additional profesionally wired fuseboxs for all none standard equiptment and relay box for associated equiptment.
2 x 12v sockets, ipad holder with charging lead
Raptor roof mounted consul housing cd player and cb
Vehicle isolator
New heater matrix and fan fitted (and it does get warm in the cab)
New heated windscreen fitted (not yet connected)
Center cubby box with 2 x cup holders
Bulkhead between cab and rear (can be removed if prefered)
Cage mounted roof lights
A frame mounted spots
Led head lights
The rear has 2 x full length drawers for tools/spares and recovery equiptment and 2x shelves above
A new offside wing and a full set of new original flexible arches are included in the sale
I have a huge awray of straps/stropes, ropes shackles, d links of varying sizes and several snatch blocks as well as spare parts = shafts, cv`s wheel bearings, uj`s etc that Could go with the old girl for the right price.
It does have a few not so great points (but then she wouldnt be a Landrover)
She is well used (but has always been well maintained)
both front wings are dented (I have a spare off side wing included in the sale as this is worst)
The water pump is very noisy so ive ordered a new one (will fit if i find time)
The chassis and bulkhead are good but could do with a little fettling with a paintbrush.
Im looking for close to £7500 and feel this is a bargin bearing in mind her capabilities and the cost to build anything close to her. She cost me over £17k to make her the machine she is today
Thankyou for looking
There are scrapes and scratches from green laning which is the only thing she was used for.
Last edited:
