wwwfc666
Active Member
Going to try rebuilding the swb series 3 tub soon
Got ali for floor and decent top hat and crossmembers
Picked up rear quarters panels new and capping etc is good
Problem is I’m replacing driver side rear wing. Picked one up with b pillar on it, so that should help
But not sure on the spot weld situation
Obviiously it’s going to be too expensive to spot weld the new panel.
I’m fine getting the spot welds out but is it just a case of rivet the new one in with silkaflex stuff as well?
Not sure if it will look right . Have heard of someone countersinking rivets?
Anyhow anyone rebuilt one? Any advices tips would be greatly appreciated. Thanks
Got ali for floor and decent top hat and crossmembers
Picked up rear quarters panels new and capping etc is good
Problem is I’m replacing driver side rear wing. Picked one up with b pillar on it, so that should help
But not sure on the spot weld situation
Obviiously it’s going to be too expensive to spot weld the new panel.
I’m fine getting the spot welds out but is it just a case of rivet the new one in with silkaflex stuff as well?
Not sure if it will look right . Have heard of someone countersinking rivets?
Anyhow anyone rebuilt one? Any advices tips would be greatly appreciated. Thanks