Q

Qhriss

New Member
Hi-After the Range Rover debacle, have repaired the Series IIA but find the speedo is knackered. I currently need the clock cw cable plus the end bit that goes in the gear box ( with three tiny screws ) as everytime I bought sepperate parts-one didn't fit with t'other :mad: S:mad:o anyone can help ? Can pay by Paypal / card ect, cheers Q
 
The screws from an old lift pump if you have one will fit the box I used this method, as the screws are a tad too long I put a nut on them to tighten up to the box.

Andy.:)
 
Mr-Tomcat said:
The screws from an old lift pump if you have one will fit the box I used this method, as the screws are a tad too long I put a nut on them to tighten up to the box.

Andy.:)
Click to expand...


or you could put a nut on the screw, cut screw to required length, run nut up to flush with end of screw, file end of screw flat and finally use the nut to clean up any burrs stil left. that way yer dint got a long screw sticking out which is likely to snap orf.

and I still int had time to get yer speedo orf. hopefully this weekend
 
If the screw is a tad longer they are a bit easier to get at with a screw driver, not talking 1/2'' out just a few mm.

Andy
 
You must log in or register to reply here.

Similar threads

W
1986 Ex-Military 110
Replies
19
Views
2K
Wonk
W
elk
Series IIA starter motor
Replies
5
Views
558
elk
elk
6
Series IIa speedometer pinion availability
Replies
1
Views
1K
jamesmartin
jamesmartin
Dr_evil
Series King Cab
61 62 63
Replies
1K
Views
119K
discomark10
discomark10