E

Elgrimio

New Member

• Jun 4, 2024

• #1

Hi,

I've been meaning to join this forum for a long time - glad to be here.

I've rebuilt the gearbox on my series 3, however when I turn the primary pinion slowly I can feel a very slight sticking point. I've tried different spacers on the layshaft but they make it worse. All the gear teeth seem fine and there's no obvious problems.

I just wondered if this is normal/ acceptable.

Thanks in advance for any help anyone is willing to offer.

 

tottot

Well-Known Member

• Jun 4, 2024

• #2

Hello and welcome. Giving a rough idea of where you are is nice.
Can not see why adjusting the lay shaft would help, all it needs is to have a tad of end float [ the book method of setting up is rather basic.]
See steamwally series 3 gearbox video's on you tube.
Just put mine back together and it turns smooth. I did need a new input shaft bearing as it was rough. When turning by hand try and keep straight as the other end is not supported by flywheel spigot bearing at this point.
What parts replaced? Have you tried it in all gears including reverse. More detail helps.

 

E

Elgrimio

New Member

• Jun 4, 2024

• #3

Steam Wally's guide is great!

I've put it all back together, tightened the layshaft bolt and the bolts for the bellhousing. It's only really slightly there - like a slight vibration through the primary pinion it's present in all gears.

I replaced the layshaft as the previous had some teeth missing and weirdly, the end was crooked. put all new bearings in across the board.

 

boguing

Well-Known Member

Full Member

• Jun 4, 2024

• #4

Have you renewed any other parts?

 

E

Elgrimio

New Member

• Jun 5, 2024

• #5

boguing said:

Have you renewed any other parts?

Click to expand...

Forgot, I also replaced the 1st/2nd Syncro unit as there were some bits broken off.

 

boguing

Well-Known Member

Full Member

• Jun 5, 2024

• #6

Elgrimio said:

Forgot, I also replaced the 1st/2nd Syncro unit as there were some bits broken off.

Click to expand...

I did wonder if you had. Could it just be a bit of eccentricity on that?

 

E

Elgrimio

New Member

• Jun 5, 2024

• #7

boguing said:

I did wonder if you had. Could it just be a bit of eccentricity on that?

Click to expand...

Ah yes could be. Do you think it's worth me replacing the syncro again?

 

E

Elgrimio

New Member

• Jun 5, 2024

• #8

Elgrimio said:

Ah yes could be. Do you think it's worth me replacing the syncro again?

Click to expand...

The only thing I'd add is that the distance piece on the end of the layshaft does seem to impact the severity of the notch. Not sure if that sways your thoughts at all.

 

boguing

Well-Known Member

Full Member

• Jun 5, 2024

• #9

Good point.

I had a look back at previous questions, and post #4 here https://www.landyzone.co.uk/land-rover/lt76-layshaft-im-confused.334034/ might be useful. James Martin used to be our gearbox guru!