Land Raver
Well-Known Member
Quick, nip up the bolts.....best fitting doors I've ever seen on a Landy! 
Nice progress
Nice progress
Land Raver
Well-Known Member
I was surprised your tank filler spout lined up with the corresponding hole in the back of the seat box. Certainly lots of Britpart new tanks don't. Mine certainly didn't.
About 18 months ago Land Rover monthly ran an article on replacing the tank and suggested that to get it to fit, the outrigger may need 'adjusting' they didn't elaborate on quite what they meant by 'adjusting the outrigger', but unsurprisingly the article was sponsored by the said manufacturer!
About 18 months ago Land Rover monthly ran an article on replacing the tank and suggested that to get it to fit, the outrigger may need 'adjusting' they didn't elaborate on quite what they meant by 'adjusting the outrigger', but unsurprisingly the article was sponsored by the said manufacturer!
Had it easy as the tank was new when I got the Land Rover so had been fitted before. The guy who sold it said he had problems with it.
jamesmartin
Well-Known Member
it does ,then usually a nut then knob though many just have the knob
Thanks the nut must be missing will have a look for one that fits I suspect that lost over the years.
series 3 sweet 16
Active Member
what colour is that is that the BONTAI GREY?
series 3 sweet 16
Active Member
Are you interested in wheels still? ONO
Update
Got the second coat on the tub (finnish coat) and the bulkhead and the back door e.t.c. Then a few spots or rain landed so I have a bit to re do. Pleased with the high shine I got from the last coat though.
Hi series 3 sweet 16
the colour ir RAL 7022 umbra grey and not shure I know what you mean about wheels?
Cheers
Got the second coat on the tub (finnish coat) and the bulkhead and the back door e.t.c. Then a few spots or rain landed so I have a bit to re do. Pleased with the high shine I got from the last coat though.
Hi series 3 sweet 16
the colour ir RAL 7022 umbra grey and not shure I know what you mean about wheels?
Cheers
Attachments
honolulujoe
Well-Known Member
looking smart, I do like that grey
Thanks Honolulu joe not sure to do the roof black again or all grey? Getting closer and hope to finish by Xmas.
Land Raver
Well-Known Member
Very nice. I'm assuming its a late model S3 looking at the brake servo and rear number plate location?
Hi Land Raver yes itÂ’s a 1982 model even has factory fitted carpets (yet to go back in)
Ok had a go at getting it running and after new points condenser and cleaning plugs found a break in the coil to dizzy wire, solved that and first touch of the key fired up!!!
Then went on to solve oil leak from oil filter housing and water leak from bottom hose, once running ok cleaned some of the engine with thinners and a rag. Also washed out breather with petrol.
My question is best way to fix the new vent seals either double sided tape or contact adhesive?
cheers
Ok had a go at getting it running and after new points condenser and cleaning plugs found a break in the coil to dizzy wire, solved that and first touch of the key fired up!!!
Then went on to solve oil leak from oil filter housing and water leak from bottom hose, once running ok cleaned some of the engine with thinners and a rag. Also washed out breather with petrol.
My question is best way to fix the new vent seals either double sided tape or contact adhesive?
cheers
Attachments
honolulujoe
Well-Known Member
iirc people have used both with good results, heavy duty double sided tape used for holding body trim in place works well apparently, or glue/silicone held in place by masking tape till it sets
