O

ossie

Member

• Oct 30, 2014

• #1

I have a 11a with a 2.5 diesel. The g/box is 11a , I intend to fit a series 111 box. What bell housing will I need?
Thanks for any help

 

D

divie

Well-Known Member

• Oct 30, 2014

• #2

I think you will need the series three bell housing and clutch, a grown up will be along soon to advise. Pop an introduction in the say hello box before the natives come along.

 

W

Webley1991

Well-Known Member

• Oct 30, 2014

• #3

Also, be aware that the Series 2 style crossmember will need to be modified to fit the series 3 clutch slave cylinder. I recently found this out the hard way.

See this thread: http://www.landyzone.co.uk/lz/f6/under-engine-crossmember-gussets-problem-268885.html

 

O

ossie

Member

• Oct 31, 2014

• #4

Thanks Webley, good information.

 

sappy75

New Member

• Oct 31, 2014

• #5

Is it a 200tdi your fitting? You can use the 2.5 bell housing with a series 3 clutch if so. You need to counterbore 4 lower holes to accept new bolts through the bell housing to the engine block.

All is explaned on the "200Di" diesel conversion for Series Land Rovers - by Glencoyne 4x4 (Thetford) website.

I followed it almost word for word when I did my conversion a couple of months ago.

 

O

ossie

Member

• Oct 31, 2014

• #6

Sappy, no it's a 2.5 n/a. But it is already in. I'm not sure what bell housing is fitted at present but I think it's a series11.