The front passenger seat back on my P38a HSE has stopped working.... I think it started after I had moved the seat base to its maximum forward position to allow for extra rear load-space.
So my best guess was that a wire or connector has either broken or become disconnected.

With a nosey around the front of the seat base I found this connector hanging unplugged. Tracing the loom back to the controls, it seems to go to the memory functions.

The weird bit is though I can't see anywhere that it can plug in!
So my questions are... is this likely to cause the seat back to not recline, and where should this plug into?!
Any ideas at all?

I'm getting dizzy hanging upside down hunting for it....

Does the heating element work ? If not take the whole seat out repair the bust wire and then you will see where it goes and of course get loads of points off her indoors for giving her a warm seat

The heating hasn't worked for some time.... although looking at the guide that looks way more than I want to get involved with at the side of the road!

Its not that hard chuck the clips away and use cable ties I took seat into kitchen when domestic management was out