I'm probably being a numpty here but, having built a new YRM seatbox and installed it, I ordered some modular seats from Exmoor trim. The position of the seat frames on the seatbox isn't self-explanatory. Is it ok to just position the frames on centre as best I can by eye or am I missing a trick?
Retroanaconda
Well-Known Member
How much of the seatbox have you replaced?
Retroanaconda
Well-Known Member
Probably best to take a reference measurement off another vehicle then, outer edge to bolt holes should do it. Then just place the seat in and mark from there.
You'll need the little tabs with captive nuts in, or you could use rivnuts.
You'll need the little tabs with captive nuts in, or you could use rivnuts.
