catman275

Active Member

Full Member

• Aug 28, 2019

• #1

Hi folks
Any recommendations for seam sealant? I am looking at brushing it on.
So many on the market, am going to use after epoxy primer on the newly galved bulkhead.
Cheers Peter

 

Chrisw8

Well-Known Member

• Aug 28, 2019

• #2

I’ve used Frost & Bilt Hamber, both good products, though I think I prefer the Frost one, seem to spread a bit easier.

 

dieseldog69

Well-Known Member

LZIR Despatch Agent

• Aug 29, 2019

• #3

I use Tiger seal, it's horrific stuff and sticks to everything, the cats got a big blob on it's tail

I like it because it softens on the application of the Hammerite and gives a warm fuzzy feeling that it stays supple and sticky.

 

catman275

Active Member

Full Member

• Sep 26, 2019

• #4

Sorry for not replying earlier. I must have missed this one.
Thanks for the suggestions.
Peter

 

dieseldog69

Well-Known Member

LZIR Despatch Agent

• Sep 26, 2019

• #5

catman275 said:

Sorry for not replying earlier. I must have missed this one.
Thanks for the suggestions.
Peter

Click to expand...

Either work very well, I have found that any PU sealant is good and can be "thinned" to a brushable state once applied and smeared, paint brush with some white spirit on it and dip it once in a while and you can get quite neat seams with it, still sticks like snot though.