D

Drakelowe

New Member
Hi,
I'm new to this forum, so I hope I'm posting this in the right place...

Does anyone know the correct torque setting for the original 1950s screw in wheel studs? I've looked everywhere I know of, without success.

I know fitting later hubs with the spline type is an option, but I'd like to replace the original screw in ones.
 
You can fit knock in studs to the early hubs.
You just have to drill the threaded holes out to suit the splines on the stud, if I remember correctly drill bit size is 9/16?
 
Last edited:
I’ve only mauled with one set of screw ins and they weren’t in an overly safe condition. I opted for a great dorb of stick weld over the back of them gouging right into the threads. Just to be on the safe side.
 
Bobsticle said:
I’ve only mauled with one set of screw ins and they weren’t in an overly safe condition. I opted for a great dorb of stick weld over the back of them gouging right into the threads. Just to be on the safe side.
Click to expand...

They will most likely crack the welds.
The proper studs are pretty cheap.
 
dag019 said:
The proper studs are the screw in ones if you are going for period correct repairs rather than modifications.
Click to expand...

I am indeed trying to keep the period studs. I know there are lots of valid arguments against this, but I've got a set of new studs and double ended lug nuts. I'm simply trying to find out what torque Land Rover originally used for the screw in studs, as I can't find it anywhere... Maybe they never did...? Does anyone out there know?
 
It would be logical that they're done to the same torque as the wheel nut themselves, no?

Perhaps with some strong threadlock to keep them there.
 
WoodyO said:
It would be logical that they're done to the same torque as the wheel nut themselves, no?

Perhaps with some strong threadlock to keep them there.
Click to expand...

I agree, but I can't find a torque figure for the double-ended nuts either - only the later nuts. All I can find for the double-ended type is "only use the wheel brace" and "don't over-tighten"... Lol.

As you suggest, I am planning to use some 721 loctite to, hopefully, keep them in place. I just don't want to bugger it up by applying too much torque :)
 
You must log in or register to reply here.

Similar threads

spins
Cylinder Head Overhaul
Replies
6
Views
505
steve2286w
steve2286w
H
1984 Land Rover 90 - Steering Wheel change
Replies
4
Views
449
dag019
dag019
Yarmite
Wheel stud pulled out
Replies
3
Views
890
Frisol
Frisol
Rockingit
What size screw? Rear air strut
Replies
5
Views
636
Rockingit
Rockingit
G
Brake servo on a 2A Diesel ?
Replies
11
Views
597
grewth
G