mick miller
Member
So, I already have some Rust Bullet, which I've used on the rear door and just started on the chassis with. However, before I begin the epic chassis paint in earnest I thought I would canvas some opinions from those that most likely have already done the same.
Rust Bullet sounded like the dogs danglies, but I have since read some less than glowing reviews. Also, the website from which I originally bought the two products from seems to have gone offline(?). That might not be too handy for getting the thing finished.
Then I read about KBS Rust Seal, which looks good but then it seems like you need 3 other products to clean and prep the metal first. Currently I'm just using the wire brush to remove any loose stuff and then a gob full of isopropyl on a rag to degrease the surface. I could do without having to purchase several expensive products before I start painting.
Then there's Dinitrol, which may be the best bet as its used by several manufacturers and I intended to either Dinitrol wax or 3M cavity wax in the chassis cavities and bulkhead after I'm done with the painting.
So, have any of you experience with these products? Do you have any longer term results to go off? Can I just say I want to avoid simply waxoiling the granny out of it because I'm not convinced from what I've read that it's the best way to go.
Your opinions are valued. Ta in advance.
Rust Bullet sounded like the dogs danglies, but I have since read some less than glowing reviews. Also, the website from which I originally bought the two products from seems to have gone offline(?). That might not be too handy for getting the thing finished.
Then I read about KBS Rust Seal, which looks good but then it seems like you need 3 other products to clean and prep the metal first. Currently I'm just using the wire brush to remove any loose stuff and then a gob full of isopropyl on a rag to degrease the surface. I could do without having to purchase several expensive products before I start painting.
Then there's Dinitrol, which may be the best bet as its used by several manufacturers and I intended to either Dinitrol wax or 3M cavity wax in the chassis cavities and bulkhead after I'm done with the painting.
So, have any of you experience with these products? Do you have any longer term results to go off? Can I just say I want to avoid simply waxoiling the granny out of it because I'm not convinced from what I've read that it's the best way to go.
Your opinions are valued. Ta in advance.