Hi there, got a nagging problem from Mrs. Toast. The rubber trim above the pedals keeps flopping down. the one i mean is the sheet with the slots in it for the pedals that covers the bulkhead in the drivers foot-well. i keep shoving it back into the channel at the top but it just keeps coming astray. There does not appear to be any kid of fixing. Am I right in thinking that I have a piece missing perhaps another length of channel that slots in sort of interference fit kind of thing? Anyone else had this?
alexander.mackinnon
Member
Mine was always falling out, i dont think there was anything missing just poor design.
I drilled a small hole through the metal tab and the rubber trim behind it and another hole just below and used a cable tie to hold it up in place ! Never fallen down again.
I drilled a small hole through the metal tab and the rubber trim behind it and another hole just below and used a cable tie to hold it up in place ! Never fallen down again.
the_wolf
Well-Known Member
the_wolf
Well-Known Member
£30Sorry I am too mean for that...cable ties or hot pishy high heels it is
Just make your own bracket. It can't be too difficult. Even a strip of metal over the edge of the rubber and riveted in place will do the job nicely
Almonds
Member
Pretty sure making one will cost you about 1000 times less, and it will be less prone to LR design faults.
Unless of course you're the monopoly man, in which case I'll sell you one for £50.
Alm.
hogie
Active Member
Toast - I had the same problem but on the passenger side. I cut a couple of wooden shims and wedged them between the metal and the sound deadening material. Worked a treat and it if you need access to those areas (which you will) it is non permanent.
I think the material is heavy and the fit gets baggy over time and it just flops down on your feet
I think the material is heavy and the fit gets baggy over time and it just flops down on your feet
