andy85

Active Member

• Jul 23, 2017

• #1

Noticed some rust on inner wheel arch when doing an unrelated job.tool wing off yesterday to sort it out and nothing could've prepared me for what happened next lol
It is absolutely shot through,the grommet hole for main loom just crumbled,all that bit down from there to the floor is shot.
Spent all day yesterday cutting it out and making templates,today Iv been welding some of it up.Didnt think these body's were that bad but that is ballsed lol

 

andy85

Active Member

• Jul 23, 2017

• #2

 

andy85

Active Member

• Jul 23, 2017

• #3

 

P

pete1987RRC

Well-Known Member

• Jul 23, 2017

• #4

THe holes are not that big.

 

andy85

Active Member

• Jul 23, 2017

• #5

Sorry mate,i apologise the rust doesn't meet your required standard.

 

P

pete1987RRC

Well-Known Member

• Jul 23, 2017

• #6

andy85 said:

Sorry mate,i apologise the rust doesn't meet your required standard.

Click to expand...

Lol

I tend to just fit new parts from YRM these days as it's so much quicker, you can get individual panels that make up the inner wing, done quite a few over the years.

Bet all joints will be suspect due to the lack of weld through prime end seam sealer at land rover.

Have fun.