I am just about to fit a new roof head lining to my 90, is there any merit in lining the roof with foam before I do this .

Steve.
 
I used that bubble wrap stuff that is foil backed. The glue I used was Nemesis High Temp Spray Adhesive from Screwfix. It’s been on for around 3-4 years now, still holding up. The only thing I regret was not adding sound deadening to the roof first.
 
Done mine with the proper pre stick 6mm foam used panel wipe to clean panel job done it cost about £30 off eBay
 
For the roof youre better off using an open cell acoustic foam. Much better soundproofing properties and noy likely to soak up water
 
Get some sound deadener as well. I have use silent coat and its good. There is dynamat and various other brands as well
 
Nope. Open on the roof. Closed everywhere else.
Going to agree to disagree on that one. Open cell foam , or sponge, will do exactly that and soak up moisture in the van.
When I did spray foam insulation, outside sheds with steel roofs were always sprayed with closed cell where as internal roof spaces were sprayed with open cell to allow timbers to breath
 
Fair point though thats in housing not cars. Most soundproofing in cars is an open cell type. Its not great for Defenders as we all know they leak water in. Opencell will soak it up and cause rot.

Seeing as its on the roof that isnt likely unless youve a severe leak in the roof.

2 years later its still dry as a bone up there.
 
Going to agree to disagree on that one. Open cell foam , or sponge, will do exactly that and soak up moisture in the van.
When I did spray foam insulation, outside sheds with steel roofs were always sprayed with closed cell where as internal roof spaces were sprayed with open cell to allow timbers to breath

Agree, Open cell to allow timbers to breathe is one thing. Land Rovers don't have timbers that need to breath.


We had a good frost a few days ago. My LD has no roof lining currently, just shiny paint, the whole inside of the roof was covered in thick frost, which later thawed and became a very wet celing dripping onto the seats and floor. I even leave the windows open a little for extra ventilation.

I have a replacement roof lining on the table at the moment, which I am recovering. There are very visible water stains on it. So even with the lining in place condensation is still prescent and probably why the linings tand to sag after a few years (well, a dozen or so).

Before I refit I will be insulating the roof with with kip-mats which are closed-cell foam. I have also made six 20mm holes in the roof lining to alow for better movement of air between the insulation and the lining.


Val.
 

Similar threads