Alpinewoodsman

Alpinewoodsman

Well-Known Member
I've got a 1986 90 with lift up handles, and they're knackered. Drivers side door keeps opening itself while driving, and fiddling with it hasn't helped. Locks are equally knackered ( as are the doors, galvanic corrosion, but I'm not replacing them..)

Trying to find replacement door mechanisms is hard work, so I was looking at replacing them with anti-burst ones.

Before spending 100 quid on handles to find out they don't fit, has anyone done this, and do they fit?
 
"All doors on 90's should be anti-burst locks."

Yes, I agree.

The old style (non anti-burst) were fitted to earlier Series vehicles but even the S111 (certainly later ones) was fitted with anti-burst mechanisms. Certainly they were fitted to the early (lift up handle) 90 & 110's. If you haven't got them then it is possible someone has retrofitted (very) early doors / handles?
Have posted a couple of photos below showing the difference (not very good but best I could source at short notice). Non anti-burst have a spring loaded latch, anti-burst have a claw.

Non anti-burst.

NON ANTI BURST LOCKS.jpg


Anti-burst.

ANTI BURST LOCK.jpg
 
Yes, 90 should be anti burst.
Even so these will open if the spring in the door unit if poor, the roller on the pillar latch is broken/missing. door hinges are worn/sloppy. or any combination of the above.
 
I dont think those locks fit in early 90 doors do they? The inside mechanism is all wrong.
 
The actual photos may be of the wrong part number, they were just to illustrate the two different types.
 
I seem to remember when I changed mine for series door the striker didn't fit the lock, so the locks are indeed different.
 
Now I'm more confused.... It's got rectangular pull handles on the inside, like this.

There has been a bodge somewhere!
6-7.png
 
The Series type anti-burst locks will fit Millitary 110/90's, your doors are the one piece doors fitted to 90/110's untill about 1986 and as you have found out, they are quite rare these days.
Could be worth giving Paddocks or similar a bell, or email them the photo.
 
There are new original spec doors available- at 400 quid each. I'll take the rear door handle off, offer up to the door, and have a look...I can always cut the door card and or door itself to fit!
 
Alpinewoodsman said:
There are new original spec doors available- at 400 quid each. I'll take the rear door handle off, offer up to the door, and have a look...I can always cut the door card and or door itself to fit!
Click to expand...
There’s a whole kit available for that, 2 doors, tops, hinges & locks. I’ve had do many problems with push button doors I’m changing to these (soon, if finances allow!).
 
ahhhh - you've got lift handle outside and pull tab inside. I have that.

Good luck finding new parts to replace bit, thats all i'm going to say
 
You must log in or register to reply here.

Similar threads

xDParis64
Right...
Replies
9
Views
1K
pwood999
pwood999
Goc3k
Discovery 1 SOLD 1997 300TDI manual D1, Winchester
Replies
16
Views
4K
Goc3k
Goc3k
P
Range Rover P38 EKA and BeCM Lockout
Replies
6
Views
4K
Doolinjames
D
300bhp/ton
Driven: New Defender - On & Off Road. Is it a Pretender?
2
Replies
29
Views
5K
tottot
tottot
PaulMc
Range Rover Classic V8 3.9 eFi Off-Roader on eBay
Replies
0
Views
2K
PaulMc
PaulMc