Hi

Finally got round to starting my Range Rover project, and what alot rust I have found.

So far I have replaced the rear crossmember, drivers side outer sill and rear drivers side seatbelt mount.

Still need to replace the drivers side footwell and both inner wings.

The question is how easy are the inner wings to replace. I have removed the driver side outer wing and can view all the rust and its definately a replacement needed. Do the old ones unbolt or are they welded and need cutting out. I see that replacement panels are available for just the arch or the complete unit including headlight mount. I am looking for easiest route not necessarily the quickest.

Thanks

Stuart

Hello mate, sorry this isn't answering your question but how did you find replacing your cross member? Mines patched to the hilt so I'd like to replace it, but was it straight forward?

Cheers

how yu getting on, Steve - they are all welded - If yu want an easy job - the complete inner wing and headlight box is available - about £250 notes!