FlyingDutchman
Active Member
Definitely not a landyzone member then.:hysterically_laughi
Used this thread to help me when my rear window gave up, luckily I'd realised it was about to go last week (when I was changing the driver's door lock due to that other Freelander favourite problem) and had ordered a kit off teabay....it arrived this morning which was lucky as the window dropped yesterday afternoon and stayed dropped!.
But I ran into problems straight away, for some reason I just couldn't get the cables to fit and keep the window clamps level. A quick browse on the bay again, looking at photos of full regulators, showed that there is more than one way to fit them, and that my car had a few bits missing (looks like it's had some work done in the tailgate before - the cut membrane was a bit of a give-away) and after another half hour I was able to get it ready to re-fit in the morning, rain permitting - have to keep it dry just in case I decide to burn it......
But I ran into problems straight away, for some reason I just couldn't get the cables to fit and keep the window clamps level. A quick browse on the bay again, looking at photos of full regulators, showed that there is more than one way to fit them, and that my car had a few bits missing (looks like it's had some work done in the tailgate before - the cut membrane was a bit of a give-away) and after another half hour I was able to get it ready to re-fit in the morning, rain permitting - have to keep it dry just in case I decide to burn it......
Stretch_TD4
New Member
Ok, so just repaired my tailgate regulator, must just say big thanks, if it wasn't for the help of you guys/gals on here would of been dam site harder! All working perfectly, took a few attempts to get cable set up propery but happy with it now. The kit I purchased off eBay was spot on!
waynesworld
New Member
Aha - a possible lifesaver.
I've spent 4 HOURS on this hateful job tonight, and ended up giving up and jamming the window up with wood until the weekend. Now I've got pictures, it should be a lot easier (especially if I can get the tension right, which I think has been my problem tonight).
I've spent 4 HOURS on this hateful job tonight, and ended up giving up and jamming the window up with wood until the weekend. Now I've got pictures, it should be a lot easier (especially if I can get the tension right, which I think has been my problem tonight).
DD3
New Member
Get a new regulator, or it will all have to come off again!
waynesworld
New Member
Hello im new to this site and my god me and the wife have had plenty problems with our td4.
I now have this same problem and I spotted this kit below on amazon can any of you please tell me if this will defo fit my Freelander TD4 06 plate so I can try and do the repair myself as yes the cables have broke
Landrover Freelander Tailgate Electric Window Regulator Repair Kit- Rear Window (Cables, Winder, Fastenings) - FREE FIRST CLASS UK POSTAGE!
I don't want to pay £95 for a full new system that I found on the internet if this will do the job and looking at the kit on amazon does it appear that the cables are already cut to size
Shaun
I now have this same problem and I spotted this kit below on amazon can any of you please tell me if this will defo fit my Freelander TD4 06 plate so I can try and do the repair myself as yes the cables have broke
Landrover Freelander Tailgate Electric Window Regulator Repair Kit- Rear Window (Cables, Winder, Fastenings) - FREE FIRST CLASS UK POSTAGE!
I don't want to pay £95 for a full new system that I found on the internet if this will do the job and looking at the kit on amazon does it appear that the cables are already cut to size
Shaun
essexpestcontrol
New Member
essexpestcontrol
New Member
some free advice;
put up an introduction post as per forum etiquette, you'll see a new members intro section
then start a new post asking the same question, rather than adding to a very old post
you may get more helpful replies
the new newbie hunter i see essex lol
Northern Irelander
Well-Known Member
Have to disagree Essex!, this is a classic thread from Michielvdv, if all info is gathered into one thread............ all the more helpful to fixing the problem (assuming there are no dead links)
Right guys need help on this I bought a full new assembly unit with motor was only £99... however I cant get the damm thing to work as it should... a few times it did and now I have managed to get the window up using the key in the backdoor so have left it alone for now.
I have no problem getting the window down but it does not seem to want to go up using the contol inside the car any ideas please as I need this fixed so the back wiper works as the MOT is due next month
I have no problem getting the window down but it does not seem to want to go up using the contol inside the car any ideas please as I need this fixed so the back wiper works as the MOT is due next month
It does not go up mate sorry for confusion and everytime we lock the doors the horn still beeps
tonytherunner
Active Member
The length of these wires are not good, anyone knows other lengths....
