B

BenH86

New Member
Hi, am trying to remove the lower dashboard from my c reg 90. Have undone all the screws that i can see but it still seems firmly stuck in place as though its been glued! Does anyone know if there's a trick to getting them off in one piece or does it seem likely that its been glued in??
Me and my gf are having a minor domestic over it (she reckons it should just come off but im sure its been stuck in place or something!)
Any help would be much appreciated,
Ben
 
Maybe they are the concealed metal press studs
and you need to ease them away with a screw driver
so you don't tear them away from the dashboard

Just guessing.. just had my back door panel off that
had 4 or 5 including screws
 
Took mine off last summer without any bother. There may be some double sided sealing tape round the heater aperture, but no concealed thingies, self tappers all round.
 
...maybe the prev owner did glue it! just keep pulling and where its tight, go investigate with a screwy behind it ;)

G
 
Ben!
It's a tractor...Just do as Griff ses..

Just keep pullin it .Its supposed to be like that :rolleyes: :D
 
which screws have you removed already?
there is quite a few.
but ffs dont try to rip it off until you are certian all the screws are out , other wise your gonna have a job putting it back.
 
Just a thought but you have taken the upper dash off first?

Heres a photo of what to expect when you get it off.

mouses nest resize.JPG

Well it could have been a cheese sarnie!!!!!!!!!!!!!!!!!!!!!1
 
i found a set of allen kens and a cornish pastie behind mine ;)

YES upper dash first! you aint going nowhere without that off 1st!

G
 
i found about 10lb of fencing staples behind mine!
there's a couple of screws fitted from underneath, which are hard to see.
 
Couldn't weigh up why it smelt so much inside till I took the dash off and found a mouses nest!
 
Thanks for ure help, took the top dashboard of and undid every screw i could find but still couldnt budge it despite lots of screwdriver proding! lol bastard must've glued it in place!
 
i very much doubt its been glued in place , unless the previous owner was a half wit with an air fix fetish.
have a look on the engine side of the bulkhead , might be nut and bolted on.
either that or it might be sealed on with silicone.
 
You must log in or register to reply here.

Similar threads

Montyjohn
P38A Any tips for getting the EAS pump piston off its spline?
Replies
18
Views
1K
gstuart
gstuart
dag019
Shocking rear shock issue
2
Replies
31
Views
4K
miktdish
miktdish
S
lock wire
Replies
2
Views
491
boguing
boguing
Montyjohn
P38A EAS Inlet Valve Stuck or leak?
Replies
7
Views
2K
Montyjohn
Montyjohn
B
Charging confusion l322
Replies
3
Views
1K
kermit_rr
kermit_rr