Zonda_

New Member
My Landy has been many colours in it's life mostly due to the army changing it's colour scheme every now and then and being hand painted since. I can't afford to get the body bead blasted so was wondering what's the best way to remove as much of the old paint as I can to give me a good base to start with?
 
Sorry that was a crap answer, Nitromors is really good if you have loads of paint on the metal, basically just apply it with a brush and wait for it to bubble up and just peel the paint off (kinda goes like pva goes on your hands).

Just make sure you wear rubber gloves!!
 
Will it not attack the windscreen seals? I also need to strip the paint of the plastic wheel arches, will it do them ok?
 
It can be used on some plastics, best to test on a small area first I guess. But I'm pretty sure it will ruin seals. If you're not taking the windows and stuff out I'd either mask them up or just use the nitromors to do the main bulk of the removal and do the bits nearest to the seals by hand.
 
Why dont you just sand it right back, beats using stripper and is a lot better for the environment and yourself. Just start with some really rough stuff like 60 or 80 and then finish off with 220.
 
Environment... snigger, you sure you're in the right place?

Yeah in holland, but i work with that **** everyday, and believe me it is better for you and a lot easier. Stripper, and the stripper that you use will take ages all depending on what type of paint has been used . We have stuff at work that will take the skin off your hands in about 30 seconds. If there is two pack or three pack on there, you will never ger it off with nitromoors
 
Last edited:
ill agree with the coarse sand paper, on a big sanding block. You only gotta make it smooth, then key it with some 240grit, then paint.

Image281.jpg
 
We stripped the works ex-mod 90 with Nitromors and it DOES EAT your seals , spats , light rubber seals and lenses oh and skin .

But if you can get your hands on a orbital sander then flat it back till its smooth and spray her , unless the body rivets are buryed in layer on layer of paint like the one I done , if it is then Nitromors is your best answer ( just take off as much plastic as u can ---- ( and no - masking tape wont stop it eating the plastic/rubber ).
 

Similar threads