Hi mate it doesn't move at all it just stays the same fully down
If the sensor changes with the DMM then I would have to say its the wrong 1 so diagnostics cant see it.

I have tried that. The last owner had replaced the plug and 1 wire was hanging off so i got a new plug and sensor but not sure if the 3 wires are the right way around

So do you only have 3 wires in the loom to the sensor? Not from the sensor. How much more has been "butchered"?

Sounds like PO has tried to shortcut something.

J
 
If the sensor changes with the DMM then I would have to say its the wrong 1 so diagnostics cant see it.



So do you only have 3 wires in the loom to the sensor? Not from the sensor. How much more has been "butchered"?

Sounds like PO has tried to shortcut something.

J
It has 3 wires going to the plug but there red blue and green now when i got the car they were black red and blue and the black 1 was disconnected so i replaced the whole lot back together but like i say the obd reader doesn't pick the fault up
 

Similar threads