P

paddyskiffler

New Member

• Oct 27, 2011

• #1

i was wanting to change the rear drive going in to the diff on my 300tdi. i want t run a 200tdi prop shaft to get rid of the rubber drive coupleing. i under stand that there are two different diffs with different spline numbers. i was wondering if there is a way to tell wich diff i have without removing it and what is the spline count i need to put in the 200 drive. cheers

 

Disco Inferno

New Member

• Oct 27, 2011

• #2

number of splines would only effect the half shafts rather than the prop I would have thought but I might be wrong. your 300 diff should be a 24 spline one but as for which prop you would need I have no idea. Just go to main stealer for the rubber donut as the cheep aftermarket ones are less than great

 

Last edited: Oct 27, 2011

bigrichsri

Active Member

• Oct 27, 2011

• #3

300's have 24 spline diffs but as inferno says, that only affects the half shafts. You need to get a new flange kit, paddocks do them, comes with new seal. Easy job, 30mins max.

 

Funkykipper

Green Laning Activist.

Forum Sponsor

• Nov 26, 2011

• #4

bigrichsri said:

300's have 24 spline diffs but as inferno says, that only affects the half shafts. You need to get a new flange kit, paddocks do them, comes with new seal. Easy job, 30mins max.

Click to expand...

The centralising pin is not an easy job. I am tearing what's left of my hair out on this. It is rooted into the flange.