DiscoLyle
Member
Cheers I will have to do some investigating. I can ways cut down the new ones of i need to.
currymunster
Well-Known Member
Good work.
I did my near side sill last summer.
Amazing what else pops up with it. Floor, wing. Inner wing.
I can post pics if you want to see?
Edit.
This is my post when I did it.
https://www.landyzone.co.uk/land-rover/oops-more-work.350211
I did my near side sill last summer.
Amazing what else pops up with it. Floor, wing. Inner wing.
I can post pics if you want to see?
Edit.
This is my post when I did it.
https://www.landyzone.co.uk/land-rover/oops-more-work.350211
Last edited:
My old ones I cut off/fell apart wer 55mm new ones from YRM matched exactly.
Has your motor seen the hot snot gun in the past and just been nailed together to get it through the test?
Has your motor seen the hot snot gun in the past and just been nailed together to get it through the test?
exactly my thoughts. I reckon it’s been stuck together/fcuked around with previously. Sorry haven’t messaged mine but will be same as Kev’s no doubt. I’ve been making carpets out of rubber lol
I've been looking at the interwebs looking for a new PAS pump that don't cost more than £175
DiscoLyle
Member
I think it has buy the previous owner. Im trying to undo it all now
currymunster
Well-Known Member
Measured mine... 55mm I'm afraid.
Are you sure the rust on the body bit hasn't just bubbled up and making it look less?
Just a thought.....
Are you sure the rust on the body bit hasn't just bubbled up and making it look less?
Just a thought.....
