Gooday,
It is a long time since I have been on here, but hopefully some one can tell me the rear top and bottom ace pipe connections.
Had the usual leak problem where the pipes go over the chassis. Took the old pipes off breaking them at the valve as expected.
Managed to plug the outlets to drive and found some good pipes from a breakers. Used a 9mm tap to remove the broken pipe ends and then found I could not feed the two connected pipes through the chassis so had to split them to feed in one at a time.
Thought it was obvious which pipe goes where so coupled it up, lots of grease on all the pipes now, no leaks even using the old seal, drives fine, but now not sure I have the pipes the correct way and can find no schematics to show routing.
So can anyone please tell me which is which.
Thanks for any reply
Frank
It is a long time since I have been on here, but hopefully some one can tell me the rear top and bottom ace pipe connections.
Had the usual leak problem where the pipes go over the chassis. Took the old pipes off breaking them at the valve as expected.
Managed to plug the outlets to drive and found some good pipes from a breakers. Used a 9mm tap to remove the broken pipe ends and then found I could not feed the two connected pipes through the chassis so had to split them to feed in one at a time.
Thought it was obvious which pipe goes where so coupled it up, lots of grease on all the pipes now, no leaks even using the old seal, drives fine, but now not sure I have the pipes the correct way and can find no schematics to show routing.
So can anyone please tell me which is which.
Thanks for any reply
Frank