K

ks68

New Member

• Jun 16, 2012

• #1

Hello
After removing the rear seats of my 110 I want to start preparing for the placement of some noisekiller matting.
I ended up in some places with the below

So 2 questions
How would you close the holes in the bodywork?
How to tackle the oxidated aluminium? I want to paint it but guess it will need first some prepping.

Any advice much appreciated

Koen

 

wiltshire landyman

I’m back

• Jun 16, 2012

• #2

rubber grommets

 

jamesmartin

Well-Known Member

• Jun 16, 2012

• #3

either clean spotlessly underneath and stick patch with aluminumcompatible liquid metal then fill top with same or rivet a patch on the top sealed under patch

 

chunkymunky

New Member

• Jun 16, 2012

• #4

Oh, erm. I fibreglass patched mine. Cheap, simples.

 

danchapman2k2

Well-Known Member

• Jun 17, 2012

• #5

Tigerseal

 

K

ks68

New Member

• Jun 17, 2012

• #6

Hi dan
Looked at the tigerseal - would you take a little alu plate and glue it with the tigerseal to the body , inside only?

Any sugestions on the prepping of the oxidated alu before Painting?

Tx

 

danchapman2k2

Well-Known Member

• Jun 17, 2012

• #7

Well depends if the area is seen you can fill it and it would hold or put plate on and stick with tigerseal

 

dieselwheasel

Active Member

• Jun 18, 2012

• #8

Rubber grommets or a small piece of alluminium plate riveted and sealed with Tigerseal.