K

ktjclc

New Member
hi all about 2 weeks ago while going down motorway for some unknown reason I felt I had lost lift ( never had a problem before) vehicle was recovered to local garage they have don't a diagnostics and data test they found faults on ecu and air suspension module faulty the module has been replaced the ecu been replaced all errors have cleared data test is saying car is functioning good but car will still not lift is there somethink that I havn`t done ie reset the air compressor is ok please if any one has any idea please advise
many thanks
karl
 
Do you have "Hard fault?". If yes and you have "35mph" message then system needs reset using diagnostics or RSW software on a lap top
Worth having a read of Wammers guide in the Technical Section at top of page
 
I havn`t had any messages come on dashboard im being told now there are no faults recorded after these items have been replaced is it possible the compressor pump could be working but not pumping enough air to lift car
 
Lift the compressor out. Three 8mm nuts.
Undo the blue pipe, 12mm spanner and start the car up. The compressor should blow your finger off the output, if not the seal has worn inside the pump. The ecu will wait for a certain amount of time for the vehicle to lift when asked. If it doesn't react it'll go into fault mode and drop to the bump stops and shout about it. Check the compressor for a good air output. ;)
 
ktjclc said:
I havn`t had any messages come on dashboard im being told now there are no faults recorded after these items have been replaced is it possible the compressor pump could be working but not pumping enough air to lift car
Click to expand...
The EAS ECU almost never fails. If the car is not lifting, it could be a hard fault which should give an error message, or a leak which could be an airspring, an air line or the valve block or even a blown fuse.
You can check the compressor using Wammers guide in the tech archive.
The garage have just replaced things without any idea what they are doing.
The only answer is diagnostics
 
Datatek said:
The EAS ECU almost never fails. If the car is not lifting, it could be a hard fault which should give an error message, or a leak which could be an airspring, an air line or the valve block or even a blown fuse.
You can check the compressor using Wammers guide in the tech archive.
The garage have just replaced things without any idea what they are doing.
The only answer is diagnostics
Click to expand...

+2.

Check Wammers post in the Technical Section and follow it through.
 
And another vote here for Wammers technical guide. If not for this logical testing regime and more than a bit of common sense from the lads on here I'd still be driving on the bump stops!
 
You must log in or register to reply here.

Similar threads

A1EK
L322 Air Suspension Inactive / HDC - gurus needed, can you help?
Replies
5
Views
3K
tyregeezer
tyregeezer
M
L322 V8 SE 2003 petrol
Replies
3
Views
469
gold rover
gold rover
E
Tracing Range Rover P38 MAF Output Problem
Replies
15
Views
2K
Grrrrrr
Grrrrrr
K
range rover p38 1995 air surspension advice needed
Replies
4
Views
331
Hippo
Hippo
A
L322 L322 Curious Air Suspension Fault
2
Replies
37
Views
7K
brianp38dse
brianp38dse