aporter

New Member

• Jan 12, 2008

• #1

My 86 range rover has the old type steering wheel (big X no padding). I have bought a later version (padded)b steering wheel, will it fit my rangie and if so any advise on how I do this?
Thanks,
Andy.

 

I

ironhorse

Active Member

• Jan 12, 2008

• #2

Andy as far as I can remember yes it will fit, however to get the old one off without a puller can be very hard work, take the centre nut off then grasp the steering wheel either side and rock it from side to side while pulling, when it releases you could end up in the back seat.

 

aporter

New Member

• Jan 13, 2008

• #3

Thanks for your reply, I'll give it a go.
Andy.

 

Geekfreek

New Member

• Jan 14, 2008

• #4

ironhorse said:

Andy as far as I can remember yes it will fit, however to get the old one off without a puller can be very hard work, take the centre nut off then grasp the steering wheel either side and rock it from side to side while pulling, when it releases you could end up in the back seat.

Click to expand...

Or if that doesn't work and you don't have a puller, Try sitting in the driving seat, shove your knees up under the wheel and push, then give the centre nut a sharp tap with a copper mallet (if you have one) while the nut is loosened just a couple of threads, don't loosen the nut to far or you risk fooking up the threads.

 

9

93Rangie

New Member

• Jan 14, 2008

• #5

Having recently changed my steering wheel to a Wood & Pickett type i'd save yourself a lot of hassle and rent yourself a puller especially if its never been off !

 

aporter

New Member

• Jan 15, 2008

• #6

Shouldn't be a problem, I'm 6' 4" and have trouble getting my knees past the steering wheel, thats why I'm looking to change it. Thanks, Andy.

 

aporter

New Member

• Jan 15, 2008

• #7

Thanks, I'll go for this if the knees + hammer don't work!