D

dickdastardly

New Member
Hi, I've had my disco for about 10 years and Have always had a problem where I turn the ignition and there's nothing. After about 5 - 10 mins of constantly turning the ignition it would go and no probs for about 4 months. Over the years it's got worse and I've resoldered and finally bypassed the spider unit and fitted a new starter motor. All the leads apear ok. I've just spent £700 on MOT and service and the Bl**dy things done it again.
Anybody got any ideas ?
 
Fuel stop solenoid?? or dodgy ignition switching unit (rear of ignition switch) or possibly steering column stalk array.
 
dickdastardly said:
Hi, I've had my disco for about 10 years and Have always had a problem where I turn the ignition and there's nothing. After about 5 - 10 mins of constantly turning the ignition it would go and no probs for about 4 months. Over the years it's got worse and I've resoldered and finally bypassed the spider unit and fitted a new starter motor. All the leads apear ok. I've just spent £700 on MOT and service and the Bl**dy things done it again.
Anybody got any ideas ?
Click to expand...

Hi, didnt u think that it could be caused by the ignition switch itself.......or did u replace it too and no joy?
 
The starter motor doesn't turn. Would the Fuel Stop solenoid cause this?


Actually I Didn't think of the ignition switch, will investigate thanks.
 
dickdastardly said:
The starter motor doesn't turn. Would the Fuel Stop solenoid cause this?
Click to expand...

No. if nothing at all suspect dodgy starter solenoid/loose connection, or steering column switch gear I had same prob and it turned out been the permanent live supply dying as soon as ignition switch was switched on I spliced in a 2nd permanent live and it cured the problem.
 
dickdastardly said:
The starter motor doesn't turn. Would the Fuel Stop solenoid cause this?


Actually I Didn't think of the ignition switch, will investigate thanks.
Click to expand...

I was writing in the same time with redhand....he was more specific...check the unit...if not follow the ignition path from the diagram with a multimeter and see where u lose the ignition's feed.
 
Cheers guys. Will try a new Ignition switch I think as the fault is intermittent and see if that cures it. Thanks for the help.
 
You must log in or register to reply here.

Similar threads

J
think have bought a 2 tonne paperweight
Replies
10
Views
792
Stanleysteamer
Stanleysteamer
G
Disco 3 (LR3) Having a nightmare Discovery 3 (2007)
Replies
17
Views
1K
gawjie
G
Swatmo
Mind of its own !
Replies
17
Views
1K
Stanleysteamer
Stanleysteamer
Cr4zyChris
Freelander 1 Td4 failing to start, part missing?
Replies
2
Views
534
Cr4zyChris
Cr4zyChris
B
Charging confusion l322
Replies
3
Views
1K
kermit_rr
kermit_rr