huffhuff

Well-Known Member

• Sep 19, 2017

• #1

Hi collective brains,

My TD5 seems to be boosting earlier than normal. Casually driving to the end of my road has me in limp mode unless i'm going super slow through the gears.

My style of driving hasn't changed and neither has my route to work. But, I am boosting higher (and sooner) than normal. As in, I used to only get up to around 20psi when flooring it in 3rd. But now, doing 40mph in 4 has me hitting the limit.

I have a stage 2 remap (TD5alive), allisport intercooler, silicone hoses, EGR blanked and a decat. Was fine for months then slowly during the last month to month and a half, i've noticed it.

What would cause this?

Ta

 

bankz5152

Well-Known Member

• Sep 19, 2017

• #2

So youre hitting max boost much quicker at lower revs? Not really a bad thing! Though if youre going limp it is, i cant remember or not you got a boost box fitted?

Though at 20psi the actuator isnt really up to the job! Ideally want to fit a bleed valve to keep the boost in check.

 

L

lynall

Well-Known Member

Full Member

• Sep 19, 2017

• #3

Check to see if the actuator pivot in the turbo itself is seizing, used to be a quite a common td5 thing.
Pliers and some oil trickles down the shaft will free it up for now

 

huffhuff

Well-Known Member

• Sep 19, 2017

• #4

Will give it a good lube. Was going to be my first port of call but work has been manic and not had time to fart let alone open my bonnet.

Ta muchly

 

huffhuff

Well-Known Member

• Sep 19, 2017

• #5

bankz5152 said:

So youre hitting max boost much quicker at lower revs? Not really a bad thing! Though if youre going limp it is, i cant remember or not you got a boost box fitted?

Though at 20psi the actuator isnt really up to the job! Ideally want to fit a bleed valve to keep the boost in check.

Click to expand...

Did have a boost box fitted but was having problems and unplugged it during process of elimination stages. Turned out to be the MAP and I never wired the box up again. However, that was ages ago and it’s been running fine and ‘normal’ with it unplugged.

I’ll wire it back up anyway

 

bankz5152

Well-Known Member

• Sep 19, 2017

• #6

Most likely is your issue... too much boost. Turn it down should run fine!!

 

gazman

Well-Known Member

• Sep 19, 2017

• #7

siezed waste gate? try disconnecting it from the actuator and it should move freely.
Mine did it when I 1st got it but has been fine ever since

 

huffhuff

Well-Known Member

• Sep 26, 2017

• #8

Plenty of this on the actuate sorted the problem...

Can the entire assembly be stripped and maintained easily? Or shall I just periodically lube it to buggery?

 

L

lynall

Well-Known Member

Full Member

• Sep 26, 2017

• #9

Nothing lasts but if it keeps it rolling so be it