RustyDefender

Well-Known Member

• Aug 12, 2024

• #1

Currently doing a new hose, does anyone know the size of the rubber hose needed to push on? The bigger hose without the crimped fitting.

 

L

lynall

Well-Known Member

Full Member

• Aug 12, 2024

• #2

What engine?

Iirc when same hose went on my 200 it was bloody expensive, so I bought a disco 200 one and cut it down lengthwise.

You can get wire reinforced silicone hose off ebay etc.

 

RustyDefender

Well-Known Member

• Aug 12, 2024

• #3

lynall said:

What engine?

Iirc when same hose went on my 200 it was bloody expensive, so I bought a disco 200 one and cut it down lengthwise.

You can get wire reinforced silicone hose off ebay etc.

Click to expand...

Yeah just both hoses either side are gone, so need to work out what size they are

 

L

lynall

Well-Known Member

Full Member

• Aug 13, 2024

• #4

RustyDefender said:

Yeah just both hoses either side are gone, so need to work out what size they are

Click to expand...

Just measure the OD of the steel pipes the duff hose slips onto.

Rough rule is, solid pipe is measured OD and flex hose/pipe is measure ID.

Auto hoses tend to a pretty std size, for example most heater hoses are 15mm ID and pas could be 19mm ID, or even larger.