Datatek
Well-Known Member
The blend motor can be accessed without removing the dash. You CANNOT splice into it from the RH lend motor and it would do no good if the blend motor is dead.
Last edited:
The left blend motor can be 'got at' from above after removing the passenger airbag module. a replacement motor can be spliced into the existing left hand motor wiring.
I am not sure I have any photos of mine from a few years ago, but I was fed up with only having hot from both sides, so I removed the left motor and set it to cold.....that way if I wanted hot I would open the right hand vents, and for cold, close the right hand and open the left hand....worked for a while until I finally fixed it properly!
I am not sure I have any photos of mine from a few years ago, but I was fed up with only having hot from both sides, so I removed the left motor and set it to cold.....that way if I wanted hot I would open the right hand vents, and for cold, close the right hand and open the left hand....worked for a while until I finally fixed it properly!
Datatek
Well-Known Member
I got at mine by removing the glove box
Hope your little ones enjoyed their Christmas Ant
Hi, I've got the glove box out but there's a large plastic air duct blocking access to the blend motor .what did you do?I got at mine by removing the glove box
Hope your little ones enjoyed their Christmas Ant
Found my thread with photos....
https://www.landyzone.co.uk/land-rover/pax-side-blend-motor-temp-fix-to-hot.172559/
https://www.landyzone.co.uk/land-rover/pax-side-blend-motor-temp-fix-to-hot.172559/
RangeRoller dt
Well-Sprung Member
Mine is like ^^^ constantly. It changes now and again to the correct setting on startup.
Have to discharge air bags system before taking anything apart or touching any yellow ducted wires. Be sure to read RAVE
Have to discharge air bags system before taking anything apart or touching any yellow ducted wires. Be sure to read RAVE
