R

rdsc1975

New Member
hello i have a 1998 2.5 range rover with a problem:rolleyes:
the cental locking no longer opens the drivers door or the passanger side door all other the doors and boot open ok. The engine won't start but will crank over but is not showing any thing on the dash eg engine immobilizer i have all so noticed after a bit the indicators stay on solid
can any body help before i doo something silly:(
 
How is the battery? P38a is very fussy about battery condition otherwise all sorts of weird things can kick off.
 
BECM getting confused by low battery volts. Check the carpets around the drivers seat, if they are wet suspect condensation in the BECM or corroded connectors.
 
rdsc1975 said:
carpets are dry
would a battery cause problems like i have said?
Click to expand...

Low battery volts can cause many problems, worth checking the under bonnet fuse box for signs/smells of burning and also for corrosion. Check the battery terminal connections and earth points, make sure the cables from the battery have not corroded away inside the plastic sleeve.

Battery voltage should be in the range of 12.5 to 12.8 volts engine off and rise to 14.0 to 14.8 volts with the engine at 2k rpm.

If the battery voltage and connections etc are all good, as already said your door locks could have fried which will most likely be due to a duff RF receiver.
 
Last edited:
think it may be the battrey as its over two years old + and its now dead flat and my charger is finding it hard to charge:( rangie was fine when i drove it home don't think it don't likes going for long runs
last owner was 80+ and she was Chauffeur driven ;) so may needs some cob webs blowing off her.will put the carlight on her when i get her going and take her up some hills:D
 
rdsc1975 said:
think it may be the battrey as its over two years old + and its now dead flat and my charger is finding it hard to charge:( rangie was fine when i drove it home don't think it don't likes going for long runs
last owner was 80+ and she was Chauffeur driven ;) so may needs some cob webs blowing off her.will put the carlight on her when i get her going and take her up some hills:D
Click to expand...

standard rr then chauffeur as standard trim level:D:D
 
rdsc1975 said:
were is the RF receiver and how can i test it:confused:
Click to expand...

It's behind the trim panel in the right hand side of the boot. Tilt the seat forward and there's a screw, then pull the plastic plugs in the boot and the trim will come off. It will be tight. For the moment just disconnect the blue wire that goes to the aerial built into the window. This will stop it picking up signals that might be causing it to operate, signals that weren't even thought of when the car was built. For you all that it means is that you will have to be close to the receiver when you press the button on the key.

When you have replaced the battery and investigated your door locks then you can come back to this and repair or replace it.
 
You must log in or register to reply here.

Similar threads

F
P38 DSE loss of power when driving
2
Replies
33
Views
2K
Mark Piercy
Mark Piercy
feyniriel
P38 alarm and immobilizer problems
2 3
Replies
42
Views
3K
Datatek
Datatek
DollyBird
Engine disabled, keys not working, tried the guide “Re-synching the Range Rover P38 diesel engine with the Solved - BECM using a Nanocom” no luck
Replies
9
Views
1K
DollyBird
DollyBird
R
Intermittent Alarm
Replies
7
Views
781
Ranger66
R
J
P38A p38 EAS - immediate drop of pressure
Replies
11
Views
625
Mark Piercy
Mark Piercy