myfirstl322
Well-Known Member
You're razor sharp so you are!
tomcat59alan
Well-Known Member
myfirstl322
Well-Known Member
AbsolutelyBet you wish you were like wot I is.
All hail to a low salt diet.
tomcat59alan
Well-Known Member
myfirstl322
Well-Known Member
That was my inferred reply to you...don't twist things.Don't swallow.
dazer200
Well-Known Member
was it that bad !
tomcat59alan
Well-Known Member
tomcat59alan
Well-Known Member
myfirstl322
Well-Known Member
Just popping into the shower...with the aid of a stick surprisingly my drain seems to be coping.
Last edited:
brianp38dse
Well-Known Member
Have a check of the brake peddle switch, if it is not set correctly as per Rave it will throw an abs fault.
Only the petrol models looking on their web siteOK, I'm obviously not up-to-date, I know that RSW do good diagnostics for the L322, I was not aware they also did it for the P38, every day is a learning day
dazer200
Well-Known Member
I should see car tomorrow as taking my L322 and new pump to get put on lets hope it works !
dazer200
Well-Known Member
Yes correct but you should be able to access the 2.5D with inpa as moduls should be the same I would think ?
tomcat59alan
Well-Known Member
Quite, but I never downloaded it I've answered that question many.times and had the problem myself so even with my memory it sticks.Or even #5
J
Yes but nanocom is a lot better, which I have the use of
Jon Dor
Well-Known Member
Keep yer hair on!You're razor sharp so you are!
dazer200
Well-Known Member
Are you sure !Or even #5
J
I was just so glad when it calibrated my suspension and drove down the road and hit 25 mph with no inactive message popping up, then I hit 40 and the real fun began, how I remember that day like it was yesterday, seems so long ago now and it was only last week ! did a full service (minus fuel pump so it seems) on wenesday and whe I went to leave my mates garage I had no power, read codes and live data on INPA with the much appriciated help of Stustrong on the phone sat in his comparing data and decided my 1.3 (should have been 4-6) on the low pressure side was not enough so have ordered a new pump came today fitting in the morning at 10am I hope ! after looking through a few forums it seems like you treat the low pressure inline as a servicable item.Quite, but I never downloaded it I've answered that question many.times and had the problem myself so even with my memory it sticks.
stuu
Well-Known Member
Should get In via e34 or e36 modules, i know the m51 engine is listed but iv never found a p38 to plug in and try,
I have a couple next time you are passing.
