Datatek
Well-Known Member
See pwood999's post.But how do I change the setting for brake switch 2?
Last edited:
See pwood999's post.But how do I change the setting for brake switch 2?
Ah good, you have corrected me.@MontyChambers did you do the Nanocom check (not while driving) on the two inputs ? No point in replacing the switch unless you're sure it's broke !!
The RAVE procedure had a missing bit between 7 & 8. It should be:
7. Extend switch plunger fully.
7a. Hold brake pedal down.
8. Fit switch & then release brake pedal.
That way the pedal sets the plunger correctly when you release the pedal.
View attachment 341450
Very helpful, tomorrow mornings job, by the way nanocom is running as it should, Hope for clear sky's tomorrow, metaphorically as well as weather-wise!If it's already in place then you can pull the plunger out with the pedal down, you don't need to remove it and risk braking it
Pun intended
the brake switch was toast, felt like it was full off grit!Very helpful, tomorrow mornings job, by the way nanocom is running as it should, Hope for clear sky's tomorrow, metaphorically as well as weather-wise!