P38 Monkey

P38 Monkey

Well-Known Member
Have searched the Forums for this but nothing found.
Question is: how to remove the interior plastic trim panel on the passenger side of the gearbox.
There are two obvious pozi screws, and the manual says remove them then pull upwards to release the panel from the clip(s).
But that doesn't work for me, and I don't like forcing things and risk hearing that splintering crack as another plastic panel bites the dust.
Any advice, as ever, very gratefully received...
 
IMG_20210926_120636_3~3.jpg
 
Undo the two screws on the window switch pack (inside cubby box). Then gently lever the rear of the trim panel with flat screwdriver, and slide the front part down to release it.
 
Theres a video on you tube. Removing center consul or something like that showing how its done Will try and find the link
 
P38 Monkey said:
Have searched the Forums for this but nothing found.
Question is: how to remove the interior plastic trim panel on the passenger side of the gearbox.
There are two obvious pozi screws, and the manual says remove them then pull upwards to release the panel from the clip(s).
But that doesn't work for me, and I don't like forcing things and risk hearing that splintering crack as another plastic panel bites the dust.
Any advice, as ever, very gratefully received...
Click to expand...
Found it its about 5mins into this one . Just enter the heading below into the Tube Total run time about 12 1/2mins
Range Rover P38 Dash Removal step by step removal
 
I was gonna post link to that video, but the guy just shows switch pack removal, and mentions sliding panels out but doesn't show it !!
 
P38 Monkey said:
Have searched the Forums for this but nothing found.
Question is: how to remove the interior plastic trim panel on the passenger side of the gearbox.
There are two obvious pozi screws, and the manual says remove them then pull upwards to release the panel from the clip(s).
But that doesn't work for me, and I don't like forcing things and risk hearing that splintering crack as another plastic panel bites the dust.
Any advice, as ever, very gratefully received...
Click to expand...

You can get the screws out so the panel sort of flaps about and then if I recall correctly you sort of pivot it up a little at the back and push down at the front and it pops out like a ball out of a socket. Think that's the right way round. Not done it in ages and memory is a bit hazy.
 
You must log in or register to reply here.

Similar threads

xDParis64
Freelander 1 Converting from wasted spark to distributor (or Visa Versa)
Replies
0
Views
394
xDParis64
xDParis64
W
Rear light cluster how to remove it
Replies
4
Views
2K
Beneagles
Beneagles
Irishrover
Disco 3 (LR3) Passenger side Temperature blend motor replacement
Replies
8
Views
6K
gstuart
gstuart
Henry_b
P38A ZF4HP24/22 Fluid Change Procedure.. "How To"
2
Replies
23
Views
5K
Henry_b
Henry_b
B
1997 P38 2.5D range rover - How to remove ABS sensor
Replies
0
Views
805
bigtoepepper
B