S

stockley

Member
My 2003 dse2,5 while driving in D the red light is on but the N red light starts flickering, so tried 3 and it’s on ok but R is flickering, dash board the same the D is there but N flashes. Plugged in bearmach says transmission no faults, any ideas?
 
No idea as I jave the manual box but I might start with reading RAVE to see how to check the cable adjustment.
 
Could be dirty contracts in the xyz switch.. razz it R-1-R a few times with the ignition off, see if it clears
 
kermit_rr said:
Could be dirty contracts in the xyz switch.. razz it R-1-R a few times with the ignition off, see if it clears
Click to expand...
Is it safe to drive? I went about 100m and came straight home. Then I went up down drive about 10 times. If gearbox had no fluid or problem, bearmach would show a DTC right?
 
Mine is a petrol, but I'd guess your gearbox is similar. I had a similar problem, was driving in D when the red light decided to flick to 1. Fortunately i wasn't driving fast enough to blow things up.
I should probably take the switch apart and clean it properly, but I've not got around to it yet.
 
You must log in or register to reply here.

Similar threads

ar1g3
P38A P38 rattle at idle
2
Replies
26
Views
3K
roythebus
R
V
Range a rover P38 Gearbox power solenoid fault
2 3
Replies
44
Views
4K
Datatek
Datatek
feyniriel
P38 1999 automatic transmission grinding
Replies
11
Views
625
Mark Piercy
Mark Piercy
F
P38 DSE loss of power when driving
2
Replies
33
Views
2K
Mark Piercy
Mark Piercy
awkwardbob
L322 2003 HSE radio connectors
Replies
4
Views
640
awkwardbob
awkwardbob