Didn’t actually get a print out of the emissions fail. I will give them a call on Monday and see if they still have it? I replaced the exhaust from the cat back and will check tomorrow that it is all tight ( if it has a leak downstream from the O2 sensors would that effect emissions?).
Did you use plenty of exhaust paste on the joints or just put them together dry & clamp up?
 
Must admit it was raining cats and dogs when I dry fitted it, so I just clamped it all together! I will get under it again today and get the job done properly! ( must admit I thought as long as the exhaust was quiet that it was doing its job, didn’t realise it might have an effect on emissions).
 
Did you use plenty of exhaust paste on the joints or just put them together dry & clamp up?


oh I hate that paste. its mucky gets everywhere, doesn't seal well and a bugger to clean off.. I prefer to use heat resistant metal tape, wrap the joint slide the seal over and tube clamp
 

Similar threads