Josiepop93
New Member
Bearmach offer the harness for about 5 quid so I'm just going to go down that route
Datatek
Well-Known Member
Is that just a short piece or the full length to the ECU? If the latter it will be time consuming to fit. Good luck with it.
Not to sure but do them buggers as well
Well I've finally tracked down the cause.. Re soldered the connectors in the interior and re built the valve block, seemed to be fine for a week, then it rained and it went all messed up again, finally got a rear right sensor fault, pulled the plug from it and found it was corroded, gave it a quick clean and spray with some electrical cleaner and it's working fine again, I shall get a new harness for that corner. Thanks for all the suggestions and at least by rebuilding the valve block and soldering that connectors I've removed possible problem points from the mix
Odd that didn't throw a fault.
