Trevor Thompson

New Member
Just thought I'd got all the problems fixed - and now it wont go!!!

Drove home OK last night and went to start it today. All seemed normal, indicatoin lights came on and off as normal, waited for heater plug lights to go out and then moved starter switch to position 3. Turned over fast enough - just wouldnt fire.

No indication that the immobilisor was on on the message display (just the usual milleage displays). No engine fault light lit.

My first thought is heater plugs. Looking at the electronic fault finding manual it looks like the ECU monitors that current is actually flowing in the heater plugs. So I would have expected a fault to be displayed. I have also checked that there is voltage getting to the heater plugs.

Hooked up the faultmate - fault code 0201B engine immobiliser line link fault - too high. fault logged. Current.

Does anyone know what that means - or even better how to fix it????

Trevor
 
Last edited:
Loss of sync? if you have a Faultmate you should be able to re-sync the BECM and the engine ECU.
 
I wondered about that - and of course I have a Faultmate FCR (which is a stand alone fault code reader). So I would have to buy that Syncmate box to resyncronise them. What concerns me is that the engine check light comes on normally (symbol looks like an injector) so it might not be syncronisation. £100 only to find it isnt the problem?
Really wish I had bought the full computer based diagnostic kit!

Susspect it is a BeCM problem though.
 
I wondered about that - and of course I have a Faultmate FCR (which is a stand alone fault code reader). So I would have to buy that Syncmate box to resyncronise them. What concerns me is that the engine check light comes on normally (symbol looks like an injector) so it might not be syncronisation. £100 only to find it isnt the problem?
Really wish I had bought the full computer based diagnostic kit!

Susspect it is a BeCM problem though.

More likely to be the fuse box than the BECM, check for signs and smells of burning around the relay bases. Check the ignition relay, check that you have fuel getting to the filter, check that the stop solenoid on the FIP is operating.
 

Similar threads