C

cpa

Active Member

• Aug 17, 2014

• #1

Hi,
Can anyone advise how to replace the driver's side heater blower? It's running slow so got replacement off ebay. Took the panel off above the knees. Looks like the motor is held on by 4 philips screws. But bit baffled how you get it past all the wiring and ducting - let alone the panel supports! Any advice very much appreciated.

 

C

cpa

Active Member

• Aug 19, 2014

• #2

Job done!

 

T

tomcat59alan

Well-Known Member

• Aug 20, 2014

• #3

Well done, was there any problems? A bit of info may help other forum users

 

J

Jamesyhunt21061988

New Member

• Sep 4, 2014

• #4

How did u manage to do this as I need to replace all three heat blend sensor motors

 

C

cpa

Active Member

• Sep 13, 2014

• #5

Hi ,
It's a matter of un clipping all the wiring and opening up the ducting to move wires out the way. Then you can get the motor out. I found it easier once the lower side trim panels were removed - gives you a bit of extra space with pushing aside the plastic ducting. It's a very close fit to get these motors out - but can be done.