R

roddy4

New Member

• Nov 19, 2011

• #1

this has happened recently,only for a few seconds from cold then calms down,is this the beginning of the end?
vehicle has done 124,ooo miles

 

Dopey

Well-Known Member

• Nov 19, 2011

• #2

Just adjust them

 

R

roddy4

New Member

• Nov 19, 2011

• #3

Dopey said:

Just adjust them

Click to expand...

adjust them i thought they were hydraulic on the p38?

 

Dopey

Well-Known Member

• Nov 19, 2011

• #4

Not on my Series II they ant, you right though

 

R

roddy4

New Member

• Nov 19, 2011

• #5

Dopey said:

Not on my Series II they ant, you right though

Click to expand...

progress eh, somethings are best left alone,what is wrong with manually adjusting tappets?

 

dogsbody

Very senior member

• Nov 19, 2011

• #6

Have you checked your oil?
Low oil, old thick oil, low oil pressure can all give a brief top end rattle before it starts to lubricate.

 

Mike v.t.s

Active Member

• Nov 19, 2011

• #7

roddy4 said:

this has happened recently,only for a few seconds from cold then calms down,is this the beginning of the end?
vehicle has done 124,ooo miles

Click to expand...

Just give it an oil service to start with, a noisy tappet is nothing to worry about normally, when the tappets start to rattle i normaly stick sum engine flush in the eng and run it for 10 mins befor i change the oil, if that doesnt cure it either chuck some new 1s in or get some tappet additive from your local motor factor and that normally shuts them up till next service, ultimatly new tappets should be fitted so excesive wear to the camshft is avoided but this doesnt mean that ur engine is ready for "the final stop" hope that helps.

 

Datatek

Well-Known Member

• Nov 20, 2011

• #8

Sure it's not just diesel clatter on cold mornings? My Transit sounds like a bag of spanners for the first 10 seconds on cold mornings, the P38 slightly less so.

 

Chrisfrain2007

Active Member

• Nov 20, 2011

• #9

Mine taps on cold mornings for abit then goes once lubed up

 

R

roddy4

New Member

• Nov 20, 2011

• #10

Chrisfrain2007 said:

Mine taps on cold mornings for abit then goes once lubed up

Click to expand...

got some tappet oil additive,just changed the oil,and levels are ok
all quite again now.

 

A

amongstit

New Member

• Nov 20, 2011

• #11

Thinner oil an option? Mine's got better after a flush and additive but not as quiet as I'd like, I'm soon to flush one more time and possibly try a thinner oil, just not sure how thin to go.