T

telboy661

New Member

• Mar 26, 2012

• #1

hi i am about to replace rear oil seal in transfer box, but in haynes manual it says replace the nut,steel and felt washer on the output flange, dose anyone know what size these are?? Or where to source ?? Or if theres a kit,, i all ready have the oil seal, but didnt want to strip landy down and not have all the bits, any help or tips welcome please.........................

 

jamesmartin

Well-Known Member

• Mar 27, 2012

• #2

dont bother ,washer and nut last forever,book is obviously written by someone who has never used either

 

T

telboy661

New Member

• Mar 27, 2012

• #3

cheers james they normally are

 

Retroanaconda

Well-Known Member

• Mar 27, 2012

• #4

To clarify on what James has said, replace the main oil seal and the felt washer. The big nut and the steel washer should be fine, though you could replace the nut as well if you wanted to be ultra secure. Nyloc nuts shouldn't be reused if you're being proper, but it's rarely an issue. Especially when done up as tight as these ones are!

 

mundungus

Active Member

• Mar 28, 2012

• #5

Tbh, ive changed both of mine and re-used the felt washer both times.

I think buster has a guide on this with lots of pictures.

 

T

telboy661

New Member

• Mar 29, 2012

• #6

hi thanks for help guys, where do i find buster??

 

T

telboy661

New Member

• Mar 29, 2012

• #7

hi now found busterbus fantastic help cheers. this is a great site guys, can spend hours reading posts.