rokertreeservices

rokertreeservices

Member
HI all i recently bought a 110 pick up which had HG failure ,Thanks mate!

I had an eratic temp gauge ,no heat etc.

Ive had the head gasket done ,temp gauge has been fine seems to be running really nice, and we have heat haha

But I'm developing a leak from this rubber grommet on the top of the engine ? any ideas?

im also getting what i think is a diesel leak dripping onto the wet road,lots of colours very noticeable .is this diesel leaking out?

any help much appreciated.

All the best
Dan
 

Attachments

  • 27157873_10213951541875987_824363986_n.jpg
    27157873_10213951541875987_824363986_n.jpg
    22.7 KB · Views: 159
If you mean the halfmoon rubber grommet, then that is the rocker gasket, needs to be refitted a simple job to do.

Diesel leak, you need to identify whereabouts in the engine ? driver side , passenger side?

Cheers
 
The most likely place for a diesel leak on a TD5 engine, if its from engine bay area is from the fuel pressure regulator (either from gasket or usually internal rubber O ring failure) which is on the drivers side of the engine (on the side of the engine near the bulk head end of the engine) with fuel pipes to and from regulator, easy enough to change but a bit of a bugger to get at. But are you sure the film on the road is not from the oil leak.
 
Hi Scooby, the fpr looks pretty clean, only the oil thats been running down back of the engine from rocker cover gasket near around the fpr from what i can see. I'm going to do the rocker cover gasket tomorrow and hopefully that cures it! Thank you
 
rokertreeservices said:
Hi Scooby, the fpr looks pretty clean, only the oil thats been running down back of the engine from rocker cover gasket near around the fpr from what i can see. I'm going to do the rocker cover gasket tomorrow and hopefully that cures it! Thank you
Click to expand...
Hope thats all it is.
 
It's good practice to use a blob of RTV sealant on those areas that aren't horizontally flat, including where the half moon is.
 
The rubber grommet on a TD5 is a full round inspection grommet that often becomes loose with age and leaks oil. You can replace it with a new one or remove and clean the old one then stick it back in with sealer / silicone.
No it can't leak diesel out of this grommet.
As mentioned by Scooby the usual diesel leak on a TD5 is the fuel pressure regulator at the offside rear of the engine.
 
Hi all , just to clarify , it is an oil leak !

I have changed the rocker cover gasket today ,

I left it running once done after about an hour I was getting a slight amount of oil coming from that rubber d at the back of the engine . Not lots but still leaking all the same , I used a little sealant around the d bit .

Should I just accept it and keep an eye on the oil, ??
 
Is it sat correctly in place?

If yes, use a bit more sealant, what sealant did you use?

Cheers
 
I use a little rtv. Degrese the area first with brake cleaner then let it set for a bit.
 
You must log in or register to reply here.

Similar threads

G
300Tdi coolant issue
Replies
2
Views
531
GilesHarrison
G
cappers
Temp gauge reads hot when lights switched on....?
Replies
7
Views
1K
Rougharse Racing
Rougharse Racing
MAF Diver
What leak is this on the driver's side of the engine bay?
Replies
4
Views
684
MAF Diver
MAF Diver
S
Smoking from oil filler
Replies
4
Views
532
Skanny78
S
Blizzard44
300tdi engine ticking noise
Replies
1
Views
1K
julianf
julianf