autogas

New Member
hi guys .
this is an odd one .
point of start of problem air suspension failed , could not read the ecu .
now the problem has grown dramatically .
engine obd working properly .
everything else no communication ,
flash the high beam and theres a delay followed by an extended flash of the lamps .
alarm going off when parked .
battery renewed following all faults above as a precaution . still will not scan .
scanners tried , snap-on and hawk eye from bermach


:confused::crazy_driver::confused:
 
I think you hve some serious corrosion in the system somewhere...

Have you had the OBD socket out to check the wiring....??
 
I think you hve some serious corrosion in the system somewhere...

Have you had the OBD socket out to check the wiring....??

hi saint no i havent dont all the protocols use the same wires ?? if not im a silly arse . but we live we learn . i will check it out mate and thanks .
 
Usual favourite for no comms on L322's was the headlight levelling ecu plug being corroded,full of green mush.Its at the bottom of the LH A pillar and has a pinkish plug.Just disconnect it and clean all the cr-p off it.Throw the ecu away - they don't work anyway.When you get good comms again use a decent tool such as Testbook to recongigure to non - levelling headlights.
 
Usual favourite for no comms on L322's was the headlight levelling ecu plug being corroded,full of green mush.Its at the bottom of the LH A pillar and has a pinkish plug.Just disconnect it and clean all the cr-p off it.Throw the ecu away - they don't work anyway.When you get good comms again use a decent tool such as Testbook to recongigure to non - levelling headlights.

this was soaked in water , i will have a really good look at these two things in daylight , i lifted it #out of a sodden carpet last week . and dried it all out . grrrrr looks likely .
 
The levelling ecu runs on the diagnostic K bus,which from memory is the one that goes back to the instrument pack where it meets the gateway to the can bus.If you look at the obd socket from memory the pins 6 and 14 that are normally used for can are blank.This is why the obd tool cant get comms.
(All from memory,so don't moan if I'm not 100% accurate)
 
eightinavee you just nailed it mate .
the sterring wheel function just sparked back into life . the headlight self level ecu is mullered , see pics
 

Attachments

  • IMG_1293.JPG
    IMG_1293.JPG
    125.1 KB · Views: 457
  • IMG_1294.JPG
    IMG_1294.JPG
    145.1 KB · Views: 516
  • IMG_1295.JPG
    IMG_1295.JPG
    86.7 KB · Views: 581
lol . i would be happy to pay it mate i have spent near 2000 quid on this f88king thing i think u just found it in 4 mins flat .
 
Anyone reading this post lift the ecu from under the carpet and cable tie it higher . before yours gets wet and corrodes
 
Despite having Testbook and access to LOTS of nice diagnostic kit,sometimes they still catch you out.Takes ages to find all the little tricks and common faults - then people start scrapping the bloody things.
Hope yours is sorted now,those headlight levelling ecu's were a a pain to LR right from the start,much better removed,and as you say cable tied up out of the swimming pool.
 
and I took mine through a big flood the other day!!!
All is well, but I don't think i'll ever do that again..

I will put door seals on my routine inspections and keep checking for water on carpets etc....

maybe I should get a 300tdi Defender......
 
and I took mine through a big flood the other day!!!
All is well, but I don't think i'll ever do that again..

I will put door seals on my routine inspections and keep checking for water on carpets etc....

maybe I should get a 300tdi Defender......
Or something reliable.
 
the water came from some little scroat smashing the passengers side door glass and stealing my snapon scanner during a monsoon .
 
Kieth.

I did look around for a Landcruiser before the l322 came along....

People are abusing their reliability with lack of maintenance...
 
Kieth.

I did look around for a Landcruiser before the l322 came along....

People are abusing their reliability with lack of maintenance...
Yep that's true, costs an arm and a leg to get a good secondhand one. Need a lottery win for a new one:)
 

Similar threads