Yep, I've no problem taking down the plastic strip which the lights fit into, however, there are two little bays in this with clear plastic and the bulbs shine into. Its these bays which are all gunked up. Anyone know if I can get the two clear plastic stips out to clean the insides?
Edit:
its the two clear plastic strips I want to take out as behind them is now very disgusting.
Edit:
its the two clear plastic strips I want to take out as behind them is now very disgusting.
Last edited:
Irishrover
Well-Known Member
No...they are all moulded together. Tip that was posted om here was to put the assembly in a dishwasher. Worth a try...you have nothiing to lose. I would think that the MOT tester is just looking for both bulbs working as opposed to how much light is emitted. After all they carry out the MOT usually in daylight.
:behindsofa:
:behindsofa:
al-one-arm
Well-Known Member
i used fairy liquid, water and a piece of wire with a cloth wrapped around it, cleaned them up a treat
Irishrover
Well-Known Member
Hi Al...has the tide come back in yet ????
:hysterically_laughi
:hysterically_laughi
al-one-arm
Well-Known Member
tide does better than me. it comes twice a day.lol
kernowdragon
Well-Known Member
Yes strictly they are; however I had little difficulty popping them out with a fine blade, scrubbed em out, and then popped em back in with a smear of clear silcone to reseal em. Then you just have to make sure the rear seals are clean and seated properly to stop the crap getting in there again. Worked a treat.
