Hi all, just got an 95 disco LPG V8 and have a few questions.

1. Cruise Control not working.
On inspection i found the bellows at the throttle was completely missing its vac pipe. Where should the over end off the pipe go?

2. Off road bumper.
Although i do take it off road, i dont feel the need for an rsj being bolted to the front, would anyone building a project in the reading area like to swap it for the original. There is a picture of it in an album on my profile.

3. Distributor.
On my initial inspection i notice that i was unable to build any pressure against the diafram (excuss spelling). I havent found a source for a replacement diafram and when i look at distributors they go on about 2 or 3 pin types. I dont know what i have got.

I think that will do for the momment. Looking forward to repiles.

Bry

One more thing. Cold Start is a Nightmare! I cant seem to find a cold stat injector. Or is extra fuel controlled by the Ecu?

1. You will require a short length of vacuum hose from the bellows to a t piece thats in the main vac hose around the rear of washer bottle area
3. If your ignition amplifer module has been replaced with a new one then it will be a 3 pin as 2 pin ones are no longer available from Land Rover. 2 pin diaphram is STC3201 and 3 pin diaphram is STC1186.

Thank you.
wow £80 pound for a bit of tin and rubber, that surprised me

you have no cold start injector ,you have temp sensor front passenger side of inlet manifold nr dizzy often fail

I thought that might be the case, thanks

Found the vacum pump and a diconected pipe that to short to get to the throotle. are the ment to be more components

Yes just a few

Electronic control unit
Driver operated switches
Brake pedal switch
Clutch pedal switch
Vehicle speed sensor
Vacuum pump
Actuator
Neutral lockout relay - automatic vehicles
Engine speed trip ECU - Manual vehicles