I have two codes...... Engine and other ECU's. Went on BBS website to confirm sign up details, pin etc.. Will drop them a line. Did all the upper/lower sh1te quite a few times. Codes stored OK on the tool and in section 1 and 2 as first time use. Some of the vids show tool with an SD card in, is that just to store any captured data, didn't have one in the box?
SD card is for data capture, not needed to get it workng.
Diesel. First two boxes.
Just checked the on-line site..... should have been boxes 7 and 8, will have another crack at it in the morning, too bloody complicated for my simple head!
I popped out tonight to have a play, deleted 1 & 2 which then kept coming back so replaced them with the original ?????, not sure if that is correct way to delete? Still showing as locked out. Going to check the obd2 connector in the morning with my Icarsoft to make sure that isn't the issue.
Got it sorted now, what a palaver?Yes it took me a while to figure out you needed to put the codes in the correct numbered boxes
Sorted now, sat in the car until 2am, it wasn't going to beat me! By accident I realised that the tool will only read BECM with ignition off whereas Engine needs to be running for comms and just ignition on for HEVAC testing? Nothing about this in any of Nanocoms destructions or on-line support? Bit poor for £500+ kit? I would at least expect a prompt from the tool rather than "computer says NO" FFS!
If you want to read the cruise control, the button needs to be on, ie. lit up. Took me ages to work that out
Which also only works on cars with the later cruise ECU !!
