Musicmaker said:

Went for a run today and noticed that the motorway ride height did not light up or adjust down, just kept on standard. Beforehand it always dropped after 30 seconds. However, after about 20 minutes the Mway indicator lit up, but I never felt it dropping as I normally do. So I locked it, then checked the heights when I got home. The rear wheels were around 445mm but the fronts were sitting at 480 mm. I thought maybe a NRV was not working, but it dropped to access mode OK. Will need to try the EASlock software to see if I can adjust them. Using this software, is it possible to reset to RR default settings, or is it a case of change the numbers on the software and measure the wheels?

Billy

Click to expand...

gfromleeds said:

It should change hight after about 1/2 mile at over 60mph

Click to expand...

mutsnutz said:

could it not be the driver pack playing silly buggers due to the heat build up in the box mine did a similar thing then i drilled holes in the box lid and its not done it since dont think that outside temp in the high 20s plus the heat from the box helps much mind

Click to expand...